ASSEMBLY INSTRUCTIONS:
Cut off the power before installing the product.
Drill a hole in the ceiling in accordance with the hole diameter specified in the installation diagram.
Connect the power connection of the product in accordance with the connection type specified in the installation diagram.
Push the springs upwards and place the product into the hole and release the springs.
The product is designed to operate at 220-240V and 50-60Hz. Do not operate it with a voltage and frequency other than these values.
The protection class (IP) is stated on the product box. The product should not be used outside the environmental and climate conditions specified by the protection class.
LED Panel is ready for use.
You can turn on the electric current.
WARRANTY CONDITIONS:
Our products are guaranteed for 2 years with one-to-one replacement.
In order for the warranty to be valid, the parts must be delivered completely to the technical service team.
If the product is defective; in accordance with Article 11 of the Consumer Protection Law No. 6502; free repairs and replacement of the product that cannot be repaired with a new product are sanctioned.
Products used outside of the instructions for use and subject to user error are not covered by the warranty.
SAFETY & WARNINGS:
Do not connect the panel without reading the user manual.
Cut off the electrical current before assembling the product.
Do not use the product other than the conditions specified by product protection class.
Installations of the panel must be carried out by specialists.
Do not use the product if the power cables are damaged.
Do not use the product in places where electricity leakage may occur.
Make sure the product is complete and correctly connected.