Bituminous Insulation Water Insulation Membrane Technical Details F-3 bituminous waterproofing membrane is a wire-reinforced fibroglass fiberglass carrier, APP (Atactic Polypropylene) additive, both sides are coated with polyethylene film and is obtained by coating the carrier with bitumen asphalt. F-3 Fibroglass waterproofing membrane is generally used on roofs, pergolas and insulation points that require waterproofing insulation. Insulation Insulation Membrane Usage Area Insulation insulation membrane foundation curtain insulation, insulation insulation in places where insulation is required in bundling. Insulation membrane parking lot terrace and sloping roofs, insulation insulation membrane Tile ceramics bottom insulation. Balcony, flower bed, terrace garden insulation where insulation is required. It is used in concrete canals. At the same time, insulation membranes are also used in rain gutters and hidden gutters. Insulation membrane retaining and basement walls, wastewater treatment plants and pressurized underground water. water tank insulation insulation. pond, swimming and ornamental pool insulation insulation. Membrane insulation is used in wet volume spaces such as kitchen, bathroom, WC, insulation and insulation membrane. Water Insulation Membrane Product Advantages Insulation membrane is flexible and durable. Insulation membrane can be easily applied to different types of surfaces. Insulation membrane has high tensile and tear strength. Insulation membrane is resistant to adverse conditions that may occur in the soil. Water insulation membrane is easily applied in details such as dilatation, chimney edge and parapet return. Insulation Water Insulation Membrane Surface Preparation The ground where the insulation membrane will be applied is cleaned from loose parts, oil and other chemicals. Surface defects are repaired with Starfix repair mortar. For a healthy application, it is recommended to use Izopak waterproofing membrane primer bitumen emulsion as a primer on the surface to be applied. Bituminous Water Insulation Membrane Application Details Bituminous insulation waterproofing membrane is applied by making 10 cm or 15 cm overlap at the joints. At the end of the roll, 15 cm overlap is made and the bituminous waterproofing membrane is heated and adhered to the entire surface with a torch flame. Insulation Bituminous Water Insulation Membrane Storage and Matters to be Considered Waterproofing membrane rolls must definitely be stored vertically. Membrane rolls must be protected from direct sunlight. After the insulation application is completed, drilling and cutting operations must not be performed. Insulation membrane applied to the terraces that are visited must be protected with floor covering.